Publicidad
Idiomas disponibles
Idiomas disponibles
Important notice on the batteries for the
metabo HPT cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used
with batteries other than these designated by us, or
when the battery is disassembled and modifi ed (such
as disassembly and replacement of cells or other
internal parts).
● To avoid injury from an accidental start, turn the switch OFF and remove the plug from the power source
or remove the battery from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualifi ed service technicians. Contact
metabo HPT Authorized Service Center.
Problem
Tool doesn't run
Tool suddenly stopped
Saw blade
-can't be attached
-fall off
Switch can't be pulled
An abnormal high-pitched
noise occurs when the
trigger switch is pulled.
Blade wears out too quickly. Proper machine oil not used when cutting
Unable to properly cut.
Battery cannot be installed
TROUBLESHOOTING GUIDE
WARNING
Possible Cause
No remaining battery power
Tool was overburdened
Battery or tool overheated
The trigger switch was held down for 5
minutes or more.
The shape of the attachment portion
doesn't match
The blade's attachment hole is worn
Lock-off button is pushed in
The trigger switch is being pulled only
slightly.
metallic materials
Too much applied pressure during
operation
Blade is inappropriate for the quality and
thickness of the material to be cut
Blade is too short for the length of the
material to be cut
Blade is worn, degraded or damaged
Attempting to install a battery other than
that specifi ed for the tool.
Possible Solution
Charge the battery.
Get rid of the problem causing the
overburden.
During operation, lighten the applied
pressure.
Allow the tool and battery to thoroughly
cool.
This is not a malfunction.
The motor was automatically stopped to
prevent failure of the tool.
Use the appropriate blade
Replace with a new blade.
Release the Lock-off button.
This is not a malfunction.
It does not occur if the trigger switch is
pulled more fully.
Use machine oil (turbine oil, etc.)
During operation, lighten the applied
pressure.
Use the proper blade
Replace with a new blade.
Please install batteries that are multi volt or
BSL18xx series.
English
19
Publicidad
