cecotec BOLERO SQUAD I 3100 Manual De Instrucciones página 38

ENGLISH
Hot sugar spills on Remove them immediately
the glass. with a spatula or razor blade
scraper suitable for induction
hobs but be careful with the
hot cooking zones.
Unplug the induction hob
1.
from the mains.
2. Hold the scraper or
cookware at a 30° angle
and scrape the dirt or
spillage onto a cool area
of the induction hob.
3. Wipe up the dirt or
spillage with a kitchen or
paper towel.
4. Follow steps 2 to 4 in the
section "Usual dirt on the
glass".
Spills on touch icons. 1. Unplug the induction hob
from the mains.
2. Blot the spill.
3. Wipe the touch icons with
a clean, damp sponge or
cloth.
4. Dry the area completely
with a paper towel.
5. Unplug the induction hob
from the mains.
B O LE R O S QUAD I 3 10 0/3 10 0 FULLFLE X/4100 FU LL F L EX
74
- Remove melted and sugary
food stains or spills as soon as
possible. If left to cool down
on the glass, they may be
difficult to remove or may even
permanently damage the glass
surface.
- Cutting hazard: when the safety
cover is retracted, the blade of
the scraper may be as sharp as
a razor. Use it with extreme care
and always store it safely and
out of the reach of children.
- The induction hob may emit an
acoustic signal and switch off,
and the touch icons may not
work if wet.
- Be sure to dry the touch icons
before switching the induction
hob back on.
6. TROUBLESHOOTING
Problem Possible causes
The induction hob There is no electricity.
does not turn on.
The touch controls do The icons are locked.
not work.
It is difficult to use the The touch icons may be
touch icons. slightly wet, or you may be
pressing them with your
fingertip.
The glass is damaged. Cookware with rough edges.
Use of inappropriate and
abrasive scouring pads or
cleaning products.
Some frying pans This is normal and may be
make crackling or due to the construction of the
popping noises. cookware (layers of different
metals vibrating differently).
The induction hob This is normal and is due to
makes a slight buzzing the induction technology, but
sound when used at the noise should decrease
high power. or disappear completely by
reducing the power setting.
BO LERO SQUA D I 3100/31 00 FULLFLEX/4100 FULLFLEX
ENGLISH
Possible solution
Make sure that the hob is
connected to the power supply
and switched on.
Check if there has been a power
failure.
If the problem persists, please
contact the official Cecotec
Technical Support Service.
Unlock the icons. See section
"Operation/Unlocking the hob" for
instructions.
Make sure the touch icons are dry
and press them with the base of
your finger.
Use cookware with flat and
smooth bases. See the "Cookware
quality" section.
Read the "Cleaning and
maintenance" section.
75