ENGLISH
Fan noise from the
The fan of the induction hob
induction hob.
helps prevent overheating.
It can continue to run even
after the induction hob has
been switched off.
The cookware does
The induction hob cannot
not heat up and the
detect the cookware because
control panel shows
the cookware is incompatible.
no indication that the
cookware is on the
The induction hob does not
hob.
detect the cookware because
it is too small for the cooking
zone or not well centred on it.
The induction hob or
Technical fault.
a cooking zone has
unexpectedly switched
off, a sound is emitted,
and an error code is
displayed (usually
alternating one or two
digits on the timer
indicator).
7. FAULT DISPLAY AND INSPECTION
If a fault occurs, the induction hob will automatically go into protection mode and display the
corresponding fault codes:
Problem
Possible causes
F3/F4
Induction-coil temperature sensor
fault.
F9/FA
Fault in the temperature sensor of the
IGBT transistor.
E1/E2
Abnormal supply voltage.
B O LE R O S QUAD I 3 10 0/3 10 0 FULLFLE X/4100 FU LL F L EX
76
This is normal and not a cause for
concern. Do not unplug the hob
from the mains if the fan is still
running.
Use only cookware compatible
with the induction hob. See the
"Cookware quality" section.
Centre the cookware and make
sure its base matches the size of
the cooking zone.
Write down the letters and
numbers of the error, unplug the
induction hob from the mains,
and contact the official Cecotec
Technical Support Service.
Possible solution
Contact the official Cecotec
Technical Support Service.
Contact the official Cecotec
Technical Support Service.
Check if the status of the power
supply is normal and if the
induction hob can be switched on
without any issues.
E3
The induction-coil sensor
temperature is too high.
E5
The IGBT sensor temperature is too
high.
Refer to these instructions to repair common faults.
Do not try to disassemble the unit on your own to avoid hazards and damages to the induction
hob.
8. TECHNICAL SPECIFICATIONS
Product
Reference:
Cut size
Total power
Energy consumption of the EChob* induction hob
Cooking zone 1
Dimensions
180 mm
Minimum detection
120 mm
Rated power*
2000 W
Booster power*
2600 W
Product
02511
Reference:
Bolero Squad I 3100 FullFlex
Cut size
560 x 490 mm
Total power
6600- 7400 W
Energy consumption of the
191.8 Wh/Kg
EChob* induction hob
Cooking
Cooking zone 2
zone 1
BO LERO SQUA D I 3100/31 00 FULLFLEX/4100 FULLFLEX
ENGLISH
Contact the official Cecotec
Technical Support Service.
Let the hob cool down and
restart it.
02510
Bolero Squad I 3100
560 x 490 mm
6600- 7400 W
192.9 Wh/Kg
Cooking zone 2
Cooking zone 3
160 mm
300 mm
100 mm
180 mm
1500 W
2500 W
1800 W
3500 W
Cooking zone 3
Bridge Zone
77