Descargar Imprimir esta página

CASO DESIGN Touch 3500 Manual Del Usuario página 46

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Attention
► If dampness penetrates into the device, this can damage the electronic components.
Please ensure that no liquid can enter the interior of the device through the ventilation
slots.
► Do not immerse the appliance in water or other liquids, and do not put it in the
dishwasher.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.
16.2 Cleaning
Ceramic hob, Housing and Operating Panel
 Clean the hob, the housing of the device and the operating panel with a soft, slightly
damp cloth.
Attention
► In order not to damage the plastic components, do not use any solvent-based cleaning
detergents such as, for example, petrol.
17 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
17.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
17.2 Fault indications
In the event of a fault, an error code will appear in the display; it describes the
cause of the fault.
Display
Description
E0
No pot detected. Place a pot suitable for induction on the device.
E01, E02
Overheating protection or short circuit. Unplug the device and let it cool down.
E03
Over- or under-voltage. Contact the customer service.
Please note
► If error messages continue to be displayed after an extended waiting period or after
restarting the appliance, then it must be sent to Customer Service to be examined.
46

Publicidad

loading

Este manual también es adecuado para:

2018