Publicidad
Idiomas disponibles
Idiomas disponibles
To prevent personal injury, always disconnect plug from power source before per-
forming any assembly, adjustment, or repair.
Installing the Rail Adjustment Knob
(Fig. 7)
1. Push the Rail Adjustment Knob 7 onto the Rod
19, orienting the hole in the center of the Knob
7 with the double D shape of the Rod 19.
2. Place the Washer 20 on the Bolt 21.
3. Using the provided Hex Wrench 32, tighten the
Bolt 21 to secure the Knob 7.
NOTE: To more easily thread the Bolt 21, place the
Bolt 21 and Washer 20 onto the end of the Hex
Wrench 32. Then carefully insert this assembly into
the Rail Adjustment Knob 7 and begin tightening.
Fig. 7
19
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 17
1609B07947_GTS15-10_Table_Saw_OSI_20230420.indd 17
Assembly
7
32
21
20
Removing and Installing the Table
Insert
Removing the Table Insert
(Fig. 8)
1. Rotate the Table Insert Lock 36 clockwise.
2. Lift the Table Insert 12 by the front edge, and
lift it clear off the table.
Fig. 8
12
12
Installing the Table Insert
(Fig. 8, Fig. 9)
1. Position the Table Insert Tab 38 into the pocket
and place the Table Insert 12 down
2. Make sure the Table Insert 12 is seated proper-
ly, and secure it in place using the Table Insert
Lock 36.
Fig. 9
12
12
38
38
A
-17-
36
36
.
B
4/20/2023 11:23:11 AM
4/20/2023 11:23:11 AM
Publicidad
