Descargar Imprimir esta página

Foppapedretti Street Manual De Instrucciones página 39

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 83
• ENGLISH •
USE IN THE VEHICLE
are extended in the same position. There must not be any space between the backrest
of the passenger seat and the car seat.
Shake the car seat to be sure it is correctly fixed in place (fig. 12, 13).
Grasp the Top Tether belt and, if necessary, lengthen the strap by pressing the
appropriate locking button, extending it to the desired length (fig. 14).
Attach the upper fixing device of the "Top Tether" to the anchoring point indicated in
the vehicle user manual (fig. 15).
Check that this icon is present inside the passenger compartment.
Tighten the Top Tether belt until the indicator turns green (fig. 15). This indicates that
the belt is tightened correctly. The Top Tether belt must pass over the backrest of the
vehicle passenger seat, it must never pass over the headrest. If necessary, lift up or
remove the headrest from the passenger seat (fig. 16).
Shake the car seat to be sure it is correctly fixed in place.
ROLL UP THE EXCESS TOP TETHER BELT AND HIDE IT AWAY, TO PREVENT YOUR
CHILD FROM PICKING IT UP AND PLAYING WITH IT, AS IT COULD BE EXTREMELY
DANGEROUS.
Press the adjustment button and at the same time grip the straps (chest belts) at the
bottom, under the pads of the chest protectors, and pull them forwards to loosen them
(fig. 17).
IMPORTANT: Do not pull on the shoulder pads.
See paragraph "Adjusting the seat belt (harness)".
Press the red button on the central buckle to release the shoulder straps (fig. 18a, 18b).
Place the shoulder straps on the sides of the car seat.
Place the child into the car seat. Place the straps over the child's shoulders, join together
the two belt tabs and hook them to the buckle. Tightening the harness (fig. 19a, 19b,
19c).
IMPORTANT! Correct adjustment of the headrest ensures maximum protection for your
child when they are inside the car seat.
When using the 5-point harness, the headrest must be adjusted so that there is 1 finger
(1 cm) gap between the shoulder straps and the top of the shoulders.
IMPORTANT: Loosen the shoulder straps before adjusting the headrest
To attach the buckle: See paragraph "Using the buckle".
Tightening the harness: See paragraph "Adjusting the seat belt (harness)".
39

Publicidad

loading

Este manual también es adecuado para:

Run