49
Description:
• During measurement, if the finger is not inserted properly, or the probe is not con-
nected or the probe is off from the finger, then "Check Probe" message prompts and
keeps blinking on the screen, and "bibibi..." alert sound appears simultaneously.
Alert sound is sustaining for about 3 minutes, and if there is no any key operation in
this period, then the device will power off automatically (if the auto power off func-
tion is enabled).
• During measurement, longtime pressing Auto-rotate/Up key "
the Auto-rotate white icon "
screen, it means the auto rotation function is enabled, if you place this oxime-
ter horizontally, then the display shows in horizontal, as shown in figure 4.2B.
Figure 4.2B Default DisplayScreen--
• Sound indicator "
the global sound by longtime pressing "
key again can disable the global sound, that's to say, the speaker is turned off at all,
therefore, no pulse beep sound, no audible alert and no key click sound.
• If the global sound is enabled by longtime pressing "
measurement, over-limit alert event or probe off event can activate the audible alert.
Refer to Section 6.2 for detailed alert indication sound.
• If the memory is full, the corresponding memory full icon appears on the screen:
"
", means temperature memory is full,"
memory is full; "
icon means the current corresponding storing space is not full. If the memory is full,
the data storing will continue in such way the new record will overwrite the oldest
record, so that it's recommended to upload the stored data into the computer in
time.
-in horizontal
" means that the global sound is disabled, the user can enable
", means SpO
ENGLISH
" appears on the upper right corner of the
". key. Longtime pressing "
" means SpO
trend record memory is full. No display of the
2
", then
", key, then during the
spot-check record
2
"