Publicidad
Idiomas disponibles
Idiomas disponibles
Noise emission value:
Noise measurement value determined in accord-
ance with EN 60745. The A-rated noise level
of the power tool is typically as follows:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Vibration emission value:
Total vibration values (vector total of three directions)
determined in accordance with EN 60745:
Screwing:
Vibration emission value
a
Uncertainty K = 1.5 m/s
Drilling in metal:
Vibration emission value
a
Uncertainty K = 1.5 m/s
NOTE
►
The vibration level specified in these instruc-
tions has been measured in accordance with
the standardised measuring procedure speci-
fied and can be used to make equipment
comparisons. The specified vibration emission
value can also be used to make an initial
exposure estimate.
WARNING!
►
The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions
in some cases. Regular use of the electric
tool in such a way may cause the user to
underestimate the vibration. Try to keep the
vibration loads as low as possible. Measures
to reduce the vibration load are, e.g. wearing
gloves and limiting the working time. Wherein
all states of operation must be included (e.g.
times when the power tool is switched off and
times where the power tool is switched on but
running without load).
PABS 20-Li D4
L
= 68.5 dB(A)
pA
K
= 3
dB
pA
L
= 79.5 dB(A)
WA
K
= 3
dB
WA
: <2.5 m/s
2
h
: 2.5 m/s
2
h,D
General Power Tool
Safety Warnings
WARNING!
►
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.
2
1. Work area safety
a) Keep work area clean and well lit.
2
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
2. Electrical safety
a) Power tool plugs must match the outlet.
Never modify the plug in any way.
Do not use any adapter plugs with earthed
(grounded) power tools.Unmodified plugs
and matching outlets will reduce risk of electric
shock.
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators.There is an increased risk of elec-
tric shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet
conditions.Water entering a power tool will
increase the risk of electric shock.
d) Do not abuse the cord. Never use the cord
for carrying, pulling or unplugging the power
tool. Keep cord away from heat, oil, sharp
edges or moving parts.Damaged or entangled
cords increase the risk of electric shock.
GB │ IE
│
15
■
Publicidad
