Publicidad
Idiomas disponibles
Idiomas disponibles
Before use
Charging the battery pack (see fig. A)
CAUTION!
►
Always pull out the plug before you remove
the battery pack
battery pack to the charger.
■
Never charge the battery pack
ambient temperature is below 10°C or above
40°C.
♦
Connect the battery pack
tery charger
(see Fig. A).
♦
Insert the power plug into the socket. The con-
trol LED
lights up red to indicate that the
appliance is charging.
♦
The green control LED
charging process is complete and the battery
pack
is ready.
♦
Insert the battery pack
ance (see Fig. B).
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦
Push the rotation direction switch
middle position (lock) (see Fig. C). Allow the bat-
tery pack
to click into the handle (see Fig. B).
Removing the battery pack:
♦
Press the release button
tery pack
(see Fig. D).
Checking the battery charge level
♦
Press the battery charge level button
the charge level of the battery (see Fig. E). The
status/remaining charge will be shown on the
battery display LED
♦
GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
│
GB │ IE
■
18
from or connect the
when the
to the rapid bat-
indicates that the
back into the appli-
into the
and remove the bat-
to check
as follows:
Changing tools
Your cordless drill has a fully automatic spindle
lock
.
When the motor is stopped, the power train locks
so that the chuck
can be opened by turning
it
. After you have attached the desired tool
and tightened it by turning the chuck
continue working (see Fig. F). The spindle lock is
automatically released when the motor starts (ON/
OFF switch
pressed).
Torque selection ring/drill setting
You can set the torque using the torque selection
ring
(see Fig. G).
♦
Select a low level for small screws or soft materials.
♦
Select a high level for large screws, hard materi-
als or removing screws.
♦
Select the drill setting for drilling work by adjust-
ing the torque selection ring
(see Fig. H).
2 speed gearbox
CAUTION!
►
Only operate the gear selection switch
when the appliance is at a standstill. Other-
wise the appliance can be damaged.
In first gear (gear selector switch
tion: 1) (see Fig. I)
you can reach a speed of approx. 400 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear (gear selector switch
position: 2) (see Fig. J)
you can reach a speed of approx. 1400 rpm for
carrying out drilling work.
, you can
to the position
in posi-
in
PABS 20-Li D4
Publicidad
