Publicidad
Idiomas disponibles
Idiomas disponibles
While operating
Keep third parties away from the power tool's area of
operation. Never work while animals or people,
especially children, are in the danger zone.
Keep the work area clean, organized and well lit (250 to 300 lux
light), thus decreasing the risk of accidents.
Always wear personal protective equipment and clothing.
Wearing a visor or goggles, dust mask, hearing protection, anti-
slip safety shoes, long-sleeved clothing, gloves and helmet
properly reduces the risk of injury.
Clothing worn during the appliance operation must be
adequate, tight and closed, for example, a work boiler suit. Do
not wear loose clothing or jewelry. Keep hair, clothing and
gloves away from rotating parts.
The following precautions and procedures should also be
followed to avoid accidents:
▪ Always keep the base firmly secured to a workbench, by
tightening the bolts;
▪ To avoid displacements or projections use clamping devices
to ensure a safe performance; Place/keep the workpiece in a
correct and stable position;
▪ Always fit the blade guard in place and in good working
condition. The blade guard should move freely and close
instantly. Never operate the power tool without the blade
guard installed;
▪ In case the saw blade gets stuck, immediately release the
trigger switch and reduce the pressure applied on the
handle;
▪ When using the sliding miter saw, adopt a stable position and
always keep your balance. Hold the power tool firmly to
ensure continuous operation and withstand unexpected
situations;
30
▪ The saw blade may become too hot while cutting. Avoid
touching it, it can cause severe burns;
▪ Do not look directly at the laser beam for a long time;
▪ Make sure that the ventilation slots are not clogged. Do not
place any objects over the ventilation slots;
▪ Avoid using the power tool on wood coated with paint
containing lead or other materials that are harmful to health.
There are certain types of powder (oak and beech) which are
classified as carcinogenic substances when they have
additives for wood preservation. Any contact or inhalation of
dust may cause allergic reactions and/or breathing disorders.
Maintenance and cleaning
Before performing cleaning, adjusting, repairing and
maintenance work, always unplug the power cord.
Replace worn out or damaged parts immediately, so that the
power tool is always in a safe operating condition.
Cleaning:
Always keep the power tool clean and dry, free from oil,
lubricants or grease. Clean all sliding miter saw components and
accessories after operation.
Do not use aggressive cleaning products. These products may
damage plastics and metals, compromising the safe operation
of the power tool.
Maintenance:
Only maintenance works described in this instruction manual
may be carried out; all other works must be performed by an
official dealer.
Use only VITO-approved saw blades and attachable accessories
for this appliance or technically identical parts. Failure to do so
may result in personal injuries or damages to the sliding miter
saw. If in doubt, if you lack knowledge or resources, you should
contact an official dealer.
Publicidad
