VITO PRO POWER VISCME255 Manual De Instrucciones página 35

Idiomas disponibles

FREQUENTLY ASKED QUESTIONS/ TROUBLESHOOTING

Question/problem - cause

Cause

The power tool does not switch on:

• The power cord is unplugged or there is an electrical

breakdown;

• The extension cord is too long or the cross-section of the

wire is too thin;

• The supply voltage is too low;

• Motor overheating;

Excessive vibrations:

• Loose bolts or parts;

• The saw blade is not installed correctly;

• The workpiece dimensions are larger than the appliance

cutting capacity;

The sliding miter saw is constantly burning the workpiece:

• The blade is damaged;

• The workpiece is being pushed too fast;

Poor cutting performance:

• The saw blade is damaged or dirty;

• The saw blade is not the appropriate for the intended

task;

• The saw blade is mounted upside down;

Solution

• Check the plug, socket and circuit breaker;

• Remove or replace the extension cord;

Plug the power cord directly into the socket;

• Check that the supply voltage is adequate;

• Let the power tool cool for 2 minutes and then turn it back

on;

• Tighten the fixing bolts and secure the loose parts;

• Install the blade correctly;

• Use workpieces according to the cutting capacity of the

tool;

• Replace the blade;

• Push the workpiece more slowly;

• Clean and replace the blade;

• Replace the saw blade with the correct one;

• Reinstall the saw blade correctly;