Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the bevel angle
1. Loosen the bevel locking lever to tilt the cutting head to the
left according to the desired bevel angle (0°- 45°);
2. The bevel angle indicator shows the angle selected on the
scale.
Using the slide rail
The slide rail (3) allows the cutting head move along the
workpieces, enabling larger cuts;
To cut with the cutting head fixed in a certain position:
1. Slide the cutting head backwards and tighten the locking bolt
on the slide rail;
When performing slide cut:
2. Loosen the slide rail locking rail and move the cutting head.
Cutting procedure
1. Raise the saw head and pull it out over the workpiece
without cutting;
2. Press the ON/OFF switch (6);
3. Press the saw head down and push the saw through the
workpiece.
Do not pull the saw through the workpiece when the
power tool is running.
Switching on the laser guide
Use the laser guide to ensure that you cut the part to the desired
size.
To switch on the laser, press the switch (2).
The laser is powered by 2 1.5V (AAA) batteries, not
included.
Sliding miter saw transport
Always secure moving parts before carrying the appliance.
1. Ensure that the spindle is locked;
2. Ensure that the miter locking handle (13) is tightened;
3. Slide the cutting head backwards all the way and tighten he
locking bolt;
4. Push the cutting head down and press the head lock-down
pin (21);
5. Always carry the tool by it carrying handle.
The lower position of the cutting head is for transport and
storage purposes only. Do not use the saw head in this
position to cut.
33
Publicidad
