Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5.
Discard the box and packing material in
compliance with local regulations.
For your personal safety, do not insert battery before
the tool is assembled completely.
7.2
PLACE THE MOWER UPRIGHT IN VERTICAL
POSITION
1.
Place the mower upright in vertical position.
2.
Remove the packing material from the cable.
3.
Remove the rubber edge guard from the upper
handle.
4.
Insert the upper handle into the lower handle.
5.
Put the bolts through the holes and tighten with
the nuts, using a Philips head screwdriver (not
included).
Do not damage the cable while installing the upper
handle.
7.3
UNFOLD THE LOWER HANDLE
1
2
1.
Pull up on the handle holes to release the lower
handles.
2.
Fold the lower handle up until the handle pins
lock into one of the two positions(P).
WARNING
WARNING
P
3
English
Make sure that the two handle pins are in the same
position.
7.4
INSTALL THE GRASS CATCHER
1.
Remove the mulch plug.
2.
Remove the side discharge chute.
3.
Open the rear discharge flap and hold it.
4.
Hold the the grass catcher by its handle and
engage the hooks on the door rod.
5.
Close the rear discharge flap.
7.5
INSTALL THE MULCH PLUG
1.
Remove the grass catcher.
2.
Open the rear discharge flap and hold it.
3.
Hold the mulch plug by its handle and fit it in the
discharge chute.
4.
Close the rear discharge flap.
10
NOTE
Publicidad
