Publicidad
Idiomas disponibles
Idiomas disponibles
2. Fit a slotted bit screwdriver to the slit (5) in the nozzle top and remove the nozzle
cap (6) by turning it fully counterclockwise.
3. Mount another supplied nozzle with a small discharge hole.
NOTE:
Choose a right nozzle out of the following two according to the kind (viscosity)
●
of the chemical you use.
Nozzle type
Aluminum nozzle (silver color) (7) *
Brass nozzle (gold color) (8) *
Brass nozzle with punch marking
(gold color) (9) *
2
Note 1: The discharge rate shown in the table is that in case of water only used for a guide line. This varies by chemicals being used.
Note 2: The type of the nozzle(s) provided with the mist blower changes from country to country.
4. Mount the top nozzle (3) and secure it with the screw (1).
NOTE:
When using an above small-amount-solution-discharge nozzle, do not mount the
●
dispersion cover (4) or deflector (optional accessory) and put it aside so that it is
not lost.
5. Set the knob (10) to the position 4.
Viscosity of chemical
High
2
Low
2
Low
Example of chemical
MALATHION (Mix the oil.)
Aqua K-Othrine (Mix the water.)
Cipermetrinato (Mix the water.)
21
(5)
(6)
(7)
(8)
(9)
Discharge rate (L/min)*
1
0.14
0.075
0.060
(3)
(10)
Publicidad
