Publicidad
Idiomas disponibles
Idiomas disponibles
Plug the battery connector into the machine
Return the seat cowling to the working position.
When using the machine, follow the instructions below.
Selection of battery charger
! ATTENTION: check that the battery charger is
compatible with the batteries being charged.
Tubular lead-acid (wet) batteries: an electronic battery
charger is recommended. In any event, contact the
external battery charger is suitable.
for this type of battery.
Preparing the battery charger
! ATTENTION: authorized service technician required
to perform this procedure.
When using a battery charger not provided with the
the machine equipment package.
The connector supplied for the external battery charger is
suitable for cables with maximum cross-section 16 mm2
remove around 13 mm of the protective sheath from the
red and black conductors of the battery charger cable;
attach the ends to the contacts of the connector and
squeeze forcibly with suitable crimping pliers;
make certain the polarity is correct (red + black –) when
attaching the wires to the connector.
Fitting the side brush
! ATTENTION: before carrying out the operations
apply the parking brake.
Assembly:
-
Undo the screw on the motor shaft.
-
Check that the drive key is located in the keyway
of the motor shaft.
-
motor shaft.
-
Retighten the clamp screw.
Disassembly:
-
Repeat the steps described above in reverse
order.
EN
16
Publicidad
