Tennant S680 Manual De Instrucciones página 20

During operation of the machine
- Keep the cleaning passes as straight as possible.
- Overlap successive cleaning passes by a few
centimetres.
- Adjust the speed of the machine according to the
type of cleaning. Use the minimum brush pressure
settings, as far as practically possible.
- Check the battery charge indicator to ensure
cleaning operation.
! ATTENTION: Do not operate the machine on slopes
or gradients steeper than indicated on the data plate.
! ATTENTION: When using the machine on gentle
gradients, do not move transversely across the
slope, but keep the machine on a line parallel to the
direction of the incline, manoeuvring carefully and
without making U-turns.
Emergency stop button
In the event of emergency, this button isolates the machine
from its power source.
To restart the machine, rotate the button.
Safety thermostat
The safety thermostat is located in the position shown.
Proceed as follows:
- Move the machine to a safe area.
- Remove the ignition key and apply the parking
brake.
- Open the debris bin and remove the source of the
heat.
Battery charge indicator
The display indicates the battery voltage: when the value
drops below a given level, all cleaning functions are
stopped, whereas the drive system remains enabled.
Refer to the section
Proceed to recharge the batteries: for this operation, refer
to the section "Recharging the batteries".
EN
.
20