Tennant S680 Manual De Instrucciones página 26

- Remove the adapter from the core of the old brush
bristles aligned in the same direction.
- Fit the new brush and make sure that the adapter
is coupled to the drive hub.
- Replace the brush compartment cover, repeating
the disassembly operations in reverse order.
Adjusting the side brushes for wear
! ATTENTION: before carrying out the operations
apply the parking brake.
due to excessive wear, they can be adjusted as follows:
- Lower the side brushes by pulling the relative
levers out and easing them down.
- Loosen the adjustment screws on the brush motor
support.
- Position the brush by hand, as required.
- Tighten the adjustment screws.
EN 26