Publicidad
Idiomas disponibles
Idiomas disponibles
English
<USB device charging stops midway>
○ Charging stops for approximately fi ve seconds to
allow the power supply to be detected under the
following conditions: if the battery charger power plug
is plugged in while charging a USB device from the
battery, or if a rechargeable battery is inserted while
charging a USB device from the battery charger.
○ USB charging stops for fi ve seconds so that checking
can be performed once the rechargeable battery has
been fully charged.
○ If the rechargeable battery level is extremely low,
charging the rechargeable battery takes priority, and
USB charging is temporarily stopped. USB charging
automatically resumes once the battery level has
reached a preset level.
BEFORE USE
Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
OPERATION
WARNING
To avoid serious accident, ensure the switch is in
the OFF position, and pull out the battery.
1. Mounting and dismounting of the bit.
<Mounting the bit. (Fig. 10)>
(1) Open the chuck jaws, and insert the bit into the chuck.
(2) Place the chuck wrench in each of the three holes
in the chuck, and turn it in the clockwise direction
(viewed from the front side). Fasten the drill chuck
fi rmly by evenly tightening with each of its 3 holes a
little at a time.
Loosen
Self-feed bit
14
Chuck Wrench
Tighten
Fig. 10
<Dismounting the bit (Fig. 10)>
To remove the bit, place the chuck wrench into one of
the holes in the chuck and turn it in the counterclockwise
direction.
2. Chuck wrench storage
The chuck wrench can be stored in the tool body.
(Fig. 11)
Chuck Wrench holder
3. Installing the side handle.
Screw the side handle into the front cover tightly.
(Fig. 12)
The side handle can be installed on either side.
Loosen
Tighten
Side handle
4. Check the rotational direction.
The bit rotates clockwise (viewed from the rear side)
by pushing the R-side of the selector switch.
The L-side of the selector switch is pushed to turn the
bit counterclockwise (See Fig. 13). (The
marks are provided on the body.)
Chuck Wrench
Fig. 11
Tighten
Loosen
Fig. 12
and
Publicidad
