Publicidad
Idiomas disponibles
Idiomas disponibles
EN
CONFIGURATION MENU
EDIT PARAMS SUBMENU
This
menu
allows
operating parameters:
1. Calibration factor (K-factor): allows the calibration
factor to be changed manually without performing the
vessel calibration process. Use the UP/DOWN buttons
to change it and press the ENTER button to confirm.
- EDIT PARAMS. -
2. If you do not wish to change this factor, press ENTER to
proceed to the next parameter.
Display orientation: This menu allows you to change
the direction of the display (normal or inverted), so that
the gun can be adapted to the specific location and the
way it is used. Use the UP/DOWN arrows to select the
desired screen direction and press the ENTER button to
confirm and exit the menu.
STRAINER MAINTENANCE
WARNING: Release all pressure within the system
!
and disconnect the air supply to the pump prior to
performing strainer replacement. Discharge pressure
The gun can be provided with a strainer (optional). To
inspect
strainer
or
following procedure:
• Remove the swivel cover (A) (optional) and loosen the
hose nut (B).
• Remove the o-ring (C) fixing the filter (D) and then filter.
• Check the filter and clean it or replace as necessary.
• Place again the filter with the o-ring and install the hose
with the swivel cover (optional).
12
105 277 R. 05/23
us
to
edit
the
FACTOR K
1000
make
replacement
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
following
You can enter an already known calibration factor or you
can
calculate
following formula:
Calibration factor =
If you do not wish to change this factor, press ENTER to
proceed to the next parameter.
operating the gun into an appropiate container and open
any bleeder-type air valves and fluid drain valver in the
system if necessary.
read
the
it
manually
according
quantity indicated on screen
actual quantity dispensed
- EDIT PARAMS. -
SCREEN
NORMAL
- EDIT PARAMS. -
SCREEN
INVERT
D
C
B
to
the
x 1000
A
Publicidad
