Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
The gun has the following dispensing modes:
STANDARD MODE, PRESET MODE and REMOTE MODE.
•
STANDARD MODE: the user can freely choose the
quantity to be dispensed without the need to validate
the work order, but it is necessary to enter it.
•
PRESET MODE: a work order must be selected in the
system in order to proceed to dispensing.
By default, the selected mode is STANDARD MODE.
However, we can modify this operation from the U-track in
STANDARD MODE OPERATION
NOTE: Before starting the dispensing process, make sure
that the trigger is not pulled.
Check that the STANDARD mode appears on the display
once the gun is started.
To dispense fluid, follow the procedure below:
1. From the user input screen, enter the user code using the
left/right buttons to change position and the up/down
buttons to select the character corresponding to the
code. The user code can contain up to 50 possible
characters, 4 will be displayed on the screen and you can
scroll to the rest using the left/right buttons.
If you wish to reset the user entered and start the
process again, press the CANCEL button. To confirm
the user, press the ENTER button and it will be sent to
the U-track for validation.
If this user does not exist in the U-track database, you
will receive an error message and you will be allowed to
re-enter another user.
2. Once the user has been validated, the next step is to
enter the JOB (work order), the buttons operation is
exactly the same as in the previous point. In STANDARD
mode, the JOB entered can be any JOB, as it does not
have to be validated by the U-track.
To reset the JOB entered and start the process again press
the CANCEL button.
To confirm the JOB entered, press the ENTER button.
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
REMOTE MODE: the user launches a transaction from the
U·Track and when the gun wakes up this transaction will
appear on the screen for approval or cancellation.
the NEXU pre-selection gun configuration section and
choose between the three available modes.
PRODUCT
STANDARD MODE
ENTER USER PIN
1
PRODUCT
ERROR USER!
SELECT JOB
1
001
001
?
001
ERROR
001
?
wo
R. 05/23 105 277
EN
5
Publicidad
