Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Mount the non-drip nozzle with the ½" bonded seal
provided (A). Tighten the nozzle nut (Aa) firmly to prevent
leakage. If using a rigid nozzle, first tighten the nut (Ab),
place in proper position the nozzle tube (B) and then tighten
the nut (C) to secure it.
Before connecting the hose to the gun, you must assemble
the swivel cover (4) into the hose (5). This cover is compatible
with ½" hoses. Depending on the hose end type (F) it may
be necessary to open the groove at the swivel cover end to
allow it to enter through the hose fitting.
To connect the hose, hold the hose end (F) stationary
while turning the swivel end (G) until the desired tightness
is achieved.
BATTERIES INSTALLATION AND REPLACEMENT
This equipment employs 4 AA 1.5 V alkaline batteries for its
operation. The gun is supplied without these batteries
installed, follow the procedure described below for
installation or replacement:
1. Remove the rubber cover (A) and then loosen the
screws (B). Remove the battery housing cover (C).
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
B
C
A
Aa
G
A
R. 05/23 105 277
EN
Ab
A
F
D
E
C
B
3
Publicidad
