Publicidad
Idiomas disponibles
Idiomas disponibles
EN
BATTERIES INSTALLATION AND REPLACEMENT
2. Install the supplied batteries (D) or equivalent batteries
(see technical specifications) according to the polarity
indicated in the battery compartment (E).
3. Place again the cover (C) and tighten the screws (B).
4. Finally, mount the rubber protector (A).
OVERVIEW
BUTTON
FUNCTION
Switching on, scrolling through
menus, changing values
UP/DOWN
Screen scrolling
LEFT/RIGHT
Cancel, go back
Confirmation / enter button
The gun automatically switches off after 30 seconds of
inactivity to save energy. To turn the display back on, press
any of the UP/DOWN keys. Once the display is activated, the
name of the equipment is briefly displayed along with the
ULink
NEXU
FW 1.10
4
105 277 R. 05/23
001
TEST
+
PRESELECTION MODE
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
E
software version installed. Next, the configured gun operating
mode is displayed and after a moment the screen where the
user can be entered is displayed. The following section
describes in detail the gun operating modes.
001
D
E
ENTER USER PIN
?
0
001
Publicidad
