Publicidad
Idiomas disponibles
Idiomas disponibles
EN
OPERATION
4. During dispensing, you can either operate the trigger
manually or you can leave the trigger fixed by means of the
locking button in the same way as described in the
standard dispensing mode. In both cases, the valve will
automatically cut off the dispensing when the preset
quantity is reached.
PRODUCT
6. If dispensing is not interrupted, when the requested
amount is reached, the valve closes automatically and the
transaction end message is sent to the U-track, returning to
the initial state to enter the user again.
DISPENSING THROUGH REMOTE MODE
In this mode, the user launches a transaction from the
UTRACK and when the gun wakes up this transaction will
appear on the screen for approval or cancellation.
1. As shown in the image above, if a transaction has been
launched from the UTRACK when the gun wakes up, the
amount associated with that transaction will be displayed
on the screen and confirmation is required to start the
transaction. To start the transaction press the ENTER
button. In case you want to cancel the transaction press
the CANCEL button.
8
105 277 R. 05/23
001
0.16
CANCEL?
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
5. If you wish to stop the dispense before it reaches the pre-
selected amount, press the CANCEL button. The display
will show "CANCEL?" on the bottom line waiting for
confirmation by pressing the ENTER button, in which case
the transaction closure will be sent to the U-track. If you do
not wish to stop the transaction press CANCEL again to
return to the previous state.
PRODUCT
0.00
CANCELLED
7. Finally, release the trigger if it was manually operated or
press it upwards and then let it return to its rest position if
you had used the locking button.
2. For safety reasons, as in the rest of the modes, before
starting the transaction, an informative message will
appear indicating that the trigger must be released; once
this action is done it is necessary to press the ENTER
button to transaction start. At this point it is also
possible to cancel the transaction start by pressing the
CANCEL button.
3. After pressing the ENTER button, we can start the
dispensing by pressing the trigger.
4. During dispensing, you can manually operate the trigger
(1) or you can leave the trigger fixed by means of the
lock button (2). In both cases, the valve will automatically
shut off the dispense when the preset amount is reached.
5. If at any time, you want to cancel or stop the transaction,
press the CANCEL button. The display will show
"CANCEL?" at the bottom of the screen and we will have
to confirm the process by pressing the ENTER button. At
this point the transaction will be closed and sent to the
UTRACK. If you do not want to stop the transaction, press
the CANCEL button again to return to the previous state.
6. If the transaction is not interrupted, when the dispensed
amount reaches the target amount, the valve will close
automatically and the transaction end message will be
sent to the UTRACK, showing on the screen that there is
no new transaction in progress ("NO TR. IN PROGRESS")
and shutting down to save battery power.
001
Publicidad
