Orion 23803 Guía De Servicio Técnico Y Recambio página 6

EN
OPERATION
3. The last step consists of entering the desired quantity,
using the UP/DOWN buttons to modify the quantity and
the LEFT/RIGHT buttons to scroll through each digit.
It must be taken into account that the maximum quantity
entered cannot exceed the "maximum quantity"
parameter that has been established from the U-track.
To reset the quantity entered and start the process again
press the CANCEL button.
To confirm the quantity entered, press the ENTER button
and the transaction initiation request will be sent to the
U-track, so that it can accept it and start the dispensing
process.
4. For safety reasons, before starting the transaction, an
information message appears indicating that the trigger
must be released; it will be necessary to confirm by
pressing the ENTER button.
5. After pressing the ENTER button we will start dispensing
by pulling the trigger.
6. During dispensing, you can manually operate the trigger
(A) or you can leave the trigger fixed by means of the
locking button (B). In both cases, the valve will
automatically shut off the dispensing when the preset
quantity is reached.
To lock the trigger in the open position: pull the trigger,
move the locking button forward with your index finger
and, holding it in this position, let the trigger down.
Once the trigger is locked, you can stop pushing the
button.
7. If you wish to stop the dispense before it reaches the
pre-selected amount, press the CANCEL button. The
display will show "CANCEL?" on the bottom line waiting
for confirmation by pressing the ENTER button, in which
case the transaction closure will be sent to the U-track. If
you do not wish to stop the transaction press CANCEL
again to return to the previous state.
6
105 277 R. 05/23
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
PRODUCT
SELECT QUANTITY
0 0 0 .0
PRODUCT
RELEASE TRIGGER, OK?
PRODUCT
0.02
B
PRODUCT
0.16
CANCEL?
PRODUCT
0.00
CANCELLED
001
001
001
3.00 L
A
001
001