Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT."
When
the ice maker
is ready
to be installed
#7 a cabinet
or directly
o17 the
floor,
you
must
adjust
the feet
to level
it and
lock the rollers.
If the.floor
is level, just
revolve
the re'o front
feet
to touch
the floor.
Reversing
the Door Swing
Tools needed:
flathead screwdriver,
Phillips screwdriver
IMPORTANT:
Before you begin, unplug the ice maker or disconnect power.
To remove
door from hinges:
1. Remove the top hinge cover.
2. Using a Phillips screwdriver,
remove the screws and take offtop hinge mat and top
hinge. Keep the parts together and set them aside.
3. Lift door off bottom hinge and turn it upside down so that the handle is on the
right.
Set door aside.
To replace
door on hinges:
1. Using a flathead screwdriver,
remove the plug buttons from the screw holes
opposite the door hinges, top and bottom.
Set aside.
2. Remove the bottom hinge, place on the opposite side at the bottom of the door.
3. Position the door on the bottom hinge.
4. Align the door on the bottom hinge and replace the top hinge and top hinge mat.
5. Replace the top hinge cover.
6. Push the plug buttons into the original screw holes.
See Figure below.
11
Publicidad
