Publicidad
Idiomas disponibles
Idiomas disponibles
.
.
.
.
.
After three minutes, the machine will automatically
go to the ice making stage, and
the sound of flowing water will be heard.
When the batch of ice has been fully formed, ice will automatically
be harvested
to
the ice storage bin.
When the ice storage bin is full, the sheet of cubes will not fall completely
and will
hold the ice-full probe open.
The machine stops making ice and automatically
progresses
to the cold preservation
stage. During this stage, the compressor
works
regularly to keep the temperature
lower to reduce ice melting.
The unit will start making ice again after the ice cubes are removed.
At that time, the
ice-full probe swings back to operating
position.
NOTE:
There
is a tray
located
inside
the unit
on top of the compressor
to catch
condensation
and splash
water.
When
this drainage
tray
is full, the machine
stops
working
and
an alarm
sounds
regularly.
Only
when
water
is drained
off
by unscrewing
the lower
drainage
nut does
the machine
start
working
again.
IMPORTANT:
•
Althoz_qh
the unit has' been tested
and cleaned
at thefactolT,
due to long-term
transit
and storage,
theJirst
batch of cubes
must be discarded.
•
Never
turn the water
supply
tap off when the ice maker
is working.
•
Never
touch the evaporator
when the machine
is running.
•
Except
to take ice from
the unit, keep the door closed
to reduce
melting
and insure
proper
ice formation.
•
Drain
the melt water
regularly
from
the ice storage
bin.
•
Drain
water
f!'om the drainage
tray above
the compressor
hy screwing
offthe
lower
drainage
nut when
the unit stops
working
and alarms
regularly.
How the Machine
Makes
Ice
Turn the ICE/OFF/WASH
switch to the ICE position.
The machine will automatically
start the ice making stage.
There are two distinct cycles: freeze and harvest.
During the freeze cycle, water flows to the evaporator
surface. In the harvest cycle, the
ice is released and water enters the machine. A complete
cycle can take 15 to 40 minutes,
depending on temperature
and operating
conditions.
Freeze:
During the freeze cycle the compressor
is pumping refrigerant,
the fan motor is
blowing air, and the water pump is circulating
water. When the batch of ice has been
fully formed, the ice maker stops the freeze cycle and begins the harvest cycle.
15
Publicidad
