Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT:
•
Drain
the melt water
regularly
or you will risk a high rate of melting
in the ice
storage
bin if the water
level reaches
the ice.
•
The unit drains
condensation
water
to the drainage
tray on top of the compressor.
(See Figure
B at bottom
of page
12.)
This water
is slowly
evaporated
by the heat
generated
by the compressor.
If the drainage
tray on top of the compressor
becomes
full of watel;
this is detected
by the Water Full Probe
and the machine
shuts
off
automatically.
At the same
time, the ice maker
sends
out an alarm
signal
and the red,
green
and yellow
LEDs
on the Control
Panel
at the back of the unitJlash
together.
Once the excess
water
is drained
throt¢qh
the drainage
nut at the bottom
of the ice
maker,
the machine
will start working
again
automatically.
Instalhttion
Types
This ice maker has been designed for Mobile Tree-standing) installation. It can also be
Enclosed (as under a cabinet) or Built-in (sealed to the floor). In every case, there must
be adequate air space around the unit for ventilation purposes (see diagrams on page 8).
Mobile Installation:
A mobile installation
will allow you to install the ice maker free-standing
in any place
you desire provided
you have access to a water supply.
You must follow the stated
instructions
for
a. Electrical
requirements
b. Water supply
c. Leveling the ice maker.
There
are four stability
supports
included
with the unit. For mobile installation,
these
supports,
which are located on the bottom
of the ice maker,
should be turned so that
two supports
extend out from each side of
the unit. (See figure.)
The supports
add
stability to the ice maker.
To secure the stability supports
in position."
Inside
the
unit
you
will find
a packet
containing
four L-shaped
brackets and eight
screws. One bracket
and two screws will be
used
to secure
each stability
support
and
keep it from rotating
out of position.
You should attach them as follows:
1. Once the stability supports have been turned outward,
adjust the bolt under each
support and also the casters under the cabinet until the unit is stable and level.
13
Publicidad
