Publicidad
Idiomas disponibles
Idiomas disponibles
GB
INSTRUCTION MANUAL MARS-SERIES INDUSTRIAL BATTERY CHARGERS
CAREFULLY READ THE FOLLOWING INSTRUCTIONS BEFORE
CONNECTING THE DEVICE TO THE POWER SUPPLY
AND / OR THE BATTERY. ALSO, MAKE SURE THAT THE SIZE OF
THE DEVICE IS APPROPRIATE FOR THE BATTERY CONNECTED TO IT.
Read these instructions carefully to make the best use of your device and
avoid future problems. Polar s.r.l. strongly recommend that you carefully
follow all the information and tips reported below for the safe use of device.
The correct use of your device will increase its working life and maximize its
efficiency. If you have any feedback for us, your suggestions will be highly
appreciated to improve the quality of our service. Thank you for your trust and
for choosing our products.
For more information, technical details, brochures or illustrative material
please contact us or visit our website:www.polar-electronics.com.
PREPARATION
Make sure that the power and charging plugs are installed.
If not, contact a specialized technician to install the connectors sized properly
for the device and the power supply. Ensure the DC and AC charging cables
are in perfect condition before proceeding with the installation. Make sure that
the main socket to which the device will be connected is properly grounded
and protected by adequate safety measures. Check the technical data shown
on the charger and ensure the device is suitable for the connected battery.
Make sure the device is positioned in a place suitable for its purpose.
Avoid placing the device in areas with sparks and/or flames, as the battery
generates explosive gases during charging. The environment in which the
charger is installed must have the minimum requirements to guarantee
operator safety and the perfect functioning of the device. Therefore it must be:
dry, ventilated and not dusty. Concerning its degree of protection, the charger
must not be exposed to splashes of water or rain in dusty or humid
environments. The charger must not be installed in places considered
dangerous concerning the processes present, such as wood processing waste
and other flammable materials.
RECOMMENDATIONS
It is advisable to fix the charger to the wall using its appropriate holes and to
make sure the air inlet and outlet openings are not obstructed, in order
to favor correct forced cooling. For the same reason, do not accumulate
materials of any kind in its proximity, do not place objects or containers for
liquids of any kind on the charger.
12.
Publicidad
