Publicidad
Idiomas disponibles
Idiomas disponibles
By touching the left button
you can change the nominal voltage of the battery
to be charged, e.g. between 12V and 24V.
By tapping the right button
the maximum charging current.
Available minimum and maximum current settings
depend on the model.
Check the battery specifications to set the charging
current.
If there is no battery information, set the current to
approximately 1/10th of capacity.
E.g.: 120Ah battery, set current to 12A.
By touching the centre button
the charging curve according to the type of battery
you are about to charge, as well as select
the 'Power Supply' mode specified later in this
section of the manual.
Check the battery specifications to choose
the charging curve.
See the section on charging curves in this manual for specifications.
Charging starts automatically on battery connection
to the switched-on charger, and no user
intervention is required.
Voltage, current and charging curve are stored
at the beginning of charging.
During charging, the display shows the percentage
estimated charge rate.
,you can change
, you can change
Voltage
24V
Current
12A
Sel Tech
WET
16.
Publicidad
