Safety And Instructional Decals - Briggs & Stratton Victa 46 23HP Manual Del Operador

13. If the fuel tank must be drained, it should be drained
outdoors.
14. Replace faulty silencers/mufflers.
15. Use only factory authorized replacement parts when making
repairs.
16. Always comply with factory specifications on all settings
and adjustments.
17. Only authorized service locations should be utilized for
major service and repair requirements.
18. Never attempt to make major repairs on this unit unless you
have been properly trained. Improper service procedures
can result in hazardous operation, equipment damage and
voiding of manufacturer's warranty.
19. On multiple blade mowers, take care as rotating one blade
can cause other blades to rotate.
20. Do not change engine governor settings or over-speed the
engine. Operating the engine at excessive speed can
increase the hazard of personal injury.
21. Disengage drive attachments, stop the engine, remove the
key, and disconnect the spark plug wire(s) before: clearing
attachment blockages and chutes, performing service work,
striking an object, or if the unit vibrates abnormally. After
striking an object, inspect the machine for damage and
make repairs before restarting and operating the equipment.
22. Never place hands near the moving parts, such as a hydro
pump cooling fan, when the tractor is running. (Hydro pump
cooling fans are typically located on top of the transaxle).
23. Units with hydraulic pumps, hoses, or motors: WARNING:
Hydraulic fluid escaping under pressure may have sufficient
force to penetrate skin and cause serious injury. If foreign
fluid is injected into the skin it must be surgically removed
within a few hours by a doctor familiar with this form of injury
or gangrene may result. Keep body and hands away from
pin holes or nozzles that eject hydraulic fluid under high
pressure. Use paper or cardboard, and not hands, to search
for leaks. Make sure all hydraulic fluid connections are tight
and all hydraulic hoses and lines are in good condition
before applying pressure to the system. If leaks occur, have
the unit serviced immediately by your authorized dealer.
24. WARNING: Stored energy device. Improper release of
springs can result in serious personal injury. Springs should
be removed by an authorized technician.
25. Models equipped with an engine radiator: WARNING: Stored
energy device. To prevent serious bodily injury from hot
coolant or steam blow-out, never attempt to remove the
radiator cap while the engine is running. Stop the engine
and wait until it is cool. Even then, use extreme care when
removing the cap.

Safety and Instructional Decals

Before operating your unit, read and understand the safety and
instructional decals (compare Figure 1 with the table below).
The cautions, warnings, and instructions are for your safety. To
avoid personal injury or damage to the unit, understand and
follow all the decals.
If any safety or instructional decals become worn or damaged,
and cannot be read, order replacement decals from your dealer.
A Decal, Tracking
Adjustment
Part No. 1759724
B Decal, Main Safety
(ANSI-Export
Models)
Part No. 1759648
C Decal, Cutting
Height
Part No. 1759253
D Decal, Engine
Speed (Choke)
Part No. 7105770
D Decal, Engine
Speed (No Choke)
Part No. 7105868
E Decal, Danger,
Thrown Objects
(ANSI-Export
Models)
Part No. 7106109
F Decal, Transmission
Release
Part No. 1758366
F Decal, Transmission
Release
(Suspension
Models)
Part No. 1758366
11