Trumpf TruTool S 160 Traduccion Del Manual De Instrucciones Originale página 18

EN
4 Consumables and
accessories
4.1 Selection of blade
The blades have 2 or 4 cutting edges. These
cannot be reground.
Depending on the thickness or density of the
workpiece, different types of blades are
needed.
With improper blade selection, the following
may happen:
– The cut quality is greatly impaired.
– The feed force increases significantly.
– The blade breaks.
For gentle work and good cutting perfor-
mance, make sure that the blades are sharp,
and that they are changed promptly.
When cutting radii, the following must be
heeded:
– Do not twist the machine.
– Work only at a low feed rate.
For notes about the selection of the correct
tool, order specifications for wearing parts
and consumables, and accessories and
spare parts lists, see:
www.trumpf.com
S 160
(2A5)
S 250
(4A5)
S 450
(3A1)
18 Translation of the original operator's manual
4.2 Alternative rechargeable
batteries
S 160
(2A5)
This power tool can be used with all
CAS LIHD 12 V and CAS LI-Ion 12 V
rechargeable batteries.
S 250
(4A5)
This power tool can be used with all
CAS LIHD 18 V and CAS LI-Ion 18 V
rechargeable batteries up to a capacity of
8 Ah.