Nordcap Moretti T98G Manual Del Usuario página 66

The burner ignites and I locked-
out in a few seconds
Burner locked
The burner does not attempt to
start
The burner comes on and after a
variable period goes into the
burner lock alarm
After installing the oven it does
not get to set-point or cannot
keep the temperature
After baking for some time, the
oven stops to maintain the
temperature during cooking
I
nverted live and neutral wires
Ineffectiveness of the detector
The Reset signal from the electronic
board relay to the flame control
Electronic board damaged
Flame control damaged
Inefficient relay slave board BURNER
Inefficiency of the detector in the
burner modulation range
Ineffective earth connection
Pressure switch defect
Lack of gas
Wrong gas supply pressure
Reset for the wrong gas type
ECO STANDBY included by default
Burner head clogged by dust
UK/29
Inverted live and neutral wires.
Ensure that the detector is at the correct
distance and that it is properly connected
Ensure that all connections from the
electronic board to the flame control are
effective and that there are no damaged
wires
Replace the electronic board
Replace the flame control
Check efficiency of the electric
connection and condition of the relays.
Replace electronic board.
Ensure that the detector is not deformed,
and reset in the correct distance if
necessary
Check electrical connection of the earth.
Ensure an effective earth connection.
NOTE: Each burner automatically nr. 3
switching cycles before displaying the
alarm BURNER BLOCK.
Check the pressure switch electrical and
pneumatic connection and ensure the
pipes are clean.
NOTE: Each burner automatically
executes 3 start cycles before displaying
the BURNER BLOCK alarm. .
Ensure continuous gas supply.
Ensure that gas supply pressure
corresponds to the table in the instruction
manual (for your country).
Ensure that the oven gas supply pressure
and the outgoing pressure from the gas
valve is 0 mbar.
Disable ECHO ST ANDBY.
Clean the burner head, remove the cause
of dust inside