CARE AND CLEANING
Step 1
Fully open the door.
Step 2
Lift and press the clamping
levers (A) on the two door
hinges.
Step 3
Close the oven door to the first opening position (approximately 70° angle). Hold the
door at both sides and pull it away from the oven at an upwards angle. Put the door
with the outer side down on a soft cloth on a stable surface.
Step 4
Hold the door trim (B) on the
top edge of the door at the
two sides and push inwards
to release the clip seal.
Step 5
Pull the door trim to the front
to remove it.
Step 6
Hold the door glass panels on
their top edge one by one and
pull them up out of the guide.
Step 7
Clean the glass panel with
water and soap. Dry the glass
panel carefully. Do not clean
the glass panels in the dish‐
washer.
Step 8
After cleaning, do the above
steps in the opposite se‐
quence.
Step 9
Install the smaller panel first, then the larger and the door.
11.6 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Step 1
28/172
B
Before you replace the lamp:
Step 2
A
2
A
1
Step 3