Cebora SYNSTAR 350 TS Manual De Instrucciones página 57

7�3�2 Push-pull torch
7�3�3 Max Inching
3301291 3301291-EN
Use knob 2 to select Push-Pull mode:
Binzel torch; for Item No 382 and 383: connect a
Binzel torch with 42 VDC motor to the wire feeder; for
Item No 379: connect a Binzel torch with a 24 VDC
motor. The machine is ready to weld. Both wire feed
motors, the main and the Push-Pull motor, are already
synchronised.
Use knob 2 to select Push-Pull Force mode.
This function adjusts the drive torque of the Push-
Pull motor in order to make the wire feed linear. The
adjustment can vary from -99 to +99.
Adjust the value by turning knob 2. Confirm the choice
by pressing knob 2 or key
DEF
Press the key to restore factory settings.
Use knob 2 to select Max Inching mode�
The purpose is to stop the welding machine if the wire
emerges for the preset length in cm after starting with
no passage of current. Adjustment OFF - 50 cm.
Use knob 2 to set the desired value. Press to confirm,
or press the key .
Press the DEF key to restore factory settings.
57