Publicidad
Idiomas disponibles
Idiomas disponibles
from being knocked over or is otherwise
EN
malfunctioning, please contact our
authorized service department. Never
attempt to disassemble the device on
your own.
All instructions in the manual for
•
recharging the battery must be strictly
followed. Failure to properly charge
the battery within the specified
temperature range could damage the
battery.
•
Only use accessories and replacement
parts recommended by the
manufacturer.
Please be extra careful when using the
•
vacuum to clean stairs.
•
Make sure the vacuum is unplugged
when not used for extended periods
as well as prior to performing any
maintenance or repairs.
Do not install, charge, or use this
•
product outdoors, in bathrooms, or
around a pool.
Fire Hazard Warning: Do not apply any
•
type of fragrance to the vacuum's filter.
These types of products are known to
contain flammable chemicals which
may cause the vacuum to catch fire.
Only use the original charger (Model
•
YLS0251B-E300080). Failing to do so
may cause the lithium-ion battery to
catch fire.
•
Only use the approved battery type
(Model V2213-7S1P-BCA). Failing to do
so may cause the lithium-ion battery to
catch fire.
If the battery material is released,
•
remove personnel from area until
the batteries cool down and fumes
dissipate.
•
Provide maximum ventilation to clear
out hazardous gases and avoid skin and
eye contact or inhalation of vapors.
Remove spilled liquid with absorbent
•
and incinerate waste.
•
Do not use and store in extremely hot or
cold environments (below 0℃ /32℉or
above 40℃ /104℉). Please charge the
12
cordless vacuum in temperature above
0℃ /32℉and below 40℃ /104℉.
This product is designed for home use
•
only.
We, Dreame Trading (Tianjin) Co., Ltd.,
hereby, declares that this equipment
is in compliance with the applicable
Directives and European Norms, and
amendments. The full text of the EU
declaration of conformity is available at
the following internet address: https://
global.dreametech.com
For detailed e-manual, please go to
https://global.dreametech.com/pages/
user-manuals-and-faqs
Product Overview
Accessories
1.Extension Rod
2.Flexible Combination Tool
3.Wide Combination Tool
4.Motorized Mini-Brush
5.Multi-Surface Brush
6.Wall Mount (Including screw ×2, wall plug
×2, and mounting template sticker )
7.Charger
8.Soft Roller Brush
Note: The images in this manual are for
illustrative purposes only. The actual
product may differ.
Fig. A
Component Names
1.Trigger switch lock
When the vacuum is running, press briefly to
switch to discontinuous/continuous cleaning
mode.
2.Lock Indicator
3.Suction Level Switch
Turbo
Med
Eco
4.Extension Rod Release Button
5.Extension Rod
6.Multi-Surface Brush
7.Antistatic Contact
8.Charging Port
9.LED Battery Status Indicator
10.Battery Release Button
11.On/Off Switch
• Press to turn on
• Release to turn off
12.Dust Cup
13.Dust Cup Bottom Cover Release Button
14.Brush Release Button
Fig. B
Installation
Fig. C-1
Wall Mount Installation
Diagram
1. Paste the mounting template sticker
on the wall. The bottom edge of the
mounting template sticker should be
parallel to and about 107cm from the
ground.
2. Use a power drill with an 8 mm drill bit
to drill a hole into each marker on the
mounting template sticker, then insert a
wall plug into each hole.
3. Align the holes on the mount with the
holes on the wall. Fasten it to the wall
with the included screws.
Fig. C-2
Note:
• The wall mount is an optional accessory.
You can install it based on your needs.
• The wall mount should be installed on a
cool, dry surface with an electrical outlet
nearby. Prior to installing, ensure that there
are no electrical wires or pipes in the space
directly behind installment position.
Charging
Fully charge the vacuum before using it for
the first time.
Note:
• A full charge will take approximately 4
hours.
• Using Turbo mode for a prolonged period
will cause the battery to heat up, which
increases charging time. Allow the vacuum
to cool down for 30 minutes before
charging it.
Charging Methods
Charging the vacuum with the charger
Fig. D-1
LED Battery Status Indicator
Low battery
Half battery
Nearly full
Fully charged
Off
Blinking
On
Note: Once the vacuum is fully charged, the
indicator will turn off after 5 minutes, and
the vacuum will enter the energy-saving
mode.
Fig. D-2
How to Use
Working Methods
Select from two working methods for the
vacuum, based on your needs.
Method 1: Discontinuous Cleaning Mode
Press and hold the on/off switch to power it
on, and release it to stop immediately.
Fig.E-1
Method 2: Continuous Cleaning Mode
(Trigger switch lock)
Click the trigger switch lock to switch
to Continuous Cleaning Mode when the
vacuum is running. Then release the on/off
switch to make the vacuum in Continuous
Cleaning Mode.
EN
13
Publicidad
