Publicidad
Idiomas disponibles
Idiomas disponibles
Charging
EN
Charging Methods
Note:
• The vacuum cannot be used while charging.
• Fully charge the vacuum before using it for the first time. This will take about 2.5 hours.
• Vacuuming at Turbo mode for a prolonged period will cause the battery to heat up,
which increases charging time. Allow the vacuum to cool down for 30 minutes before
charging it.
Display Screen
Battery Status Indicator
• Red: Battery Level ＜ 20%
• White: Battery Level ≥ 20%
Battery Indicator
The battery indicators flash and then turn bright constantly in sequence depending on the
battery condition.
Note: The screen will turn off if there is no operation for more than 30 seconds.
8
How to Use
Working Methods
Select from two working methods for the vacuum, based on your needs.
Method 1: Discontinuous Cleaning Mode
Press and hold the on/off switch to power it on, and release it to stop immediately.
Method 2: Continuous Cleaning Mode (Electronic Lock)
Click the
button to switch to Continuous Cleaning Mode and the
release the on/off switch to make the vacuum in Continuous Cleaning Mode.
Use the electronic lock to free your fingers and avoid finger fatigue caused by holding the
switch.
Notes:
• In this mode, briefly press the switch to suspend the operation or start again， and the
working mode of the vacuum will not change.
• Click the electronic lock again to quit the Continuous Cleaning Mode.
EN
button is on. Then
9
Publicidad
