Publicidad
Idiomas disponibles
Idiomas disponibles
Installing SDS-plus® Accessories
(Fig. 2)
Clean the insert shank end of the accessory to
remove any debris, then lightly grease with a
light oil or lubricant.
Insert accessory into the chuck through the dust
shield, while twisting and pushing inward until it
locks automatically into place. Pull outward on
the accessory to be certain it is locked into the
chuck.
Note: The high efficiency available from the ro-
tary hammers can only be obtained if sharp and
undamaged accessories are used. The "cost" to
maintain sharp and undamaged accessories is
more than offset by the "time saved" in operat-
ing the tool with sharp accessories.
Removing SDS-plus® Accessories
Accessories may be hot af-
ter use. Avoid contact with
skin and use proper protective gloves or cloth to
remove.
(Fig. 3)
To remove an accessory, pull locking sleeve 4
backward and pull bit forward. All accessories
should be wiped clean after removing.
160992A8B9 GBH18V-28C 20230316.indd 12
Assembly
Fig. 2
Fig. 3
-12-
(4)
3/16/23 4:08 PM
Publicidad
