Publicidad
Idiomas disponibles
Idiomas disponibles
GFCI and personal protection devices like elec-
trician's rubber gloves and footwear will further
enhance your personal safety.
Do not use AC only rated tools with a DC power
supply. While the tool may appear to work, the
electrical components of the AC rated tool are
likely to fail and create a hazard to the operator.
Keep handles dry, clean and free from oil and
grease. Slippery hands cannot safely control the
power tool.
Develop a periodic maintenance schedule for
your tool. When cleaning a tool be careful not
to disassemble any portion of the tool since
internal wires may be misplaced or pinched or
safety guard return springs may be improperly
mounted. Certain cleaning agents such as gaso-
line, carbon tetrachloride, ammonia, etc. may
damage plastic parts.
Ensure the switch is in the off position before
inserting battery pack. Inserting the battery
pack into power tools that have the switch on
invites accidents.
The manufacturer is not responsible for radio
interference caused by unauthorized modifica-
tions to this equipment. Such modifications
could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interfer-
ence, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE! This equipment has been tested and
found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide rea-
sonable protection against harmful interference
in a residential installation. This equipment gen-
erates, uses and can radiate radio frequency
energy and, if not installed and used in accor-
dance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not
160992A8B9 GBH18V-28C 20230316.indd 6
Additional Safety Warnings
page heading
drilling, and other construction activities con-
tains chemicals known to cause cancer, birth
defects or other reproductive harm. Some ex-
amples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and
• Arsenic and chromium from chemically-treat-
Your risk from these exposures varies, depend-
ing on how often you do this type of work. To re-
duce your exposure to these chemicals: work in
a well ventilated area, and work with approved
safety equipment, such as those dust masks
that are specially designed to filter out micro-
scopic particles.
FCC Caution
occur in a particular installation. If this equip-
ment does cause harmful interference to radio
or television reception, which can be deter-
mined by turning the equipment off and on, the
user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
• Connect the equipment into an outlet on a cir-
• Consult the dealer or an experienced radio/
"Exposure to Radio Frequency (RF) Signals:
The wireless device is a radio transmitter and
receiver. It is designed and manufactured not
to exceed the emission limit for exposure to ra-
dio frequency (RF) energy set by the Ministry
of Health (Canada), Safety Code 6. These limits
are part of comprehensive guidelines and estab-
lished permitted levels of RF energy for the gen-
eral population.
-6-
Some dust created by power
sanding, sawing, grinding,
other masonry products, and
ed lumber.
ment and receiver.
cuit different from that to which the receiver
is connected.
TV technician for help.
3/16/23 4:08 PM
Publicidad
