Kärcher WD 7.2 Serie Manual Del Usuario página 17

Note: After several filter cleaning pro-
cesses or if the filter cleaning indicator
is red, check the container for its fill vol-
ume. Empty the container if needed.
Wet vacuum cleaning
 Attach the accessories to vacuum mois-
ture or wetness to the suction pipes or
directly to the handle.
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full a float closes
the suction opening and the appliance
works at a higher speed. Switch off the ap-
pliance immediately and empty the contain-
er.
Working with electrical power tools
 Adapt the adapter to the connection di-
ameter of the electric tool using a knife
if necessary.
Illustration
 A) Plug the enclosed adapter onto the
handle of the suction hose and connect
the electric tool with the connection.
or
B) Use the flexible tool hose to gain
more flexibility in your work. Connect
this hose to the suction hose and to the
adapter and then to the connection of
the electric tool.
Illustration
 For appliances with built-in socket:
Connect the mains plug of the electric
power tool to the vacuum cleaner.
 Switch the appliance on (move the rota-
ry switch to the left to position
MAX) and start working.
Note: The suction turbine starts with a
delay of 0.5 seconds after the electric
tool has been switched on. After the
electric tool has been switched off, the
suction turbine will continue to run for
approx. 5 seconds to suck in the re-
maining dirt from the suction hose.
Blowing function
Cleaning hard to reach locations or, where
vacuuming is not possible, like leaves from
a gravel bed.
Illustration
 Connect the suction hose to the blower
connection, this will activate the blower
function.
Interrupting operation
 Turn off the appliance.
Illustration
 Hook the floor nozzle into the parking
position.
Finish operation
 Turn off the appliance and disconnect
the mains plug.
Empty the container
Illustration
 Remove the appliance head and empty
the reservoir filled with wet or dry dirt.
Storing the appliance
Illustration H
 Store the accessories and the mains
cable on the appliance and store the
appliance in dry rooms.
Maintenance and care
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorized customer service.
Caution
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.
 Clean the appliance and accessory
parts made of plastic with a commercial
plastic cleaner.
 If required, rinse the container and ac-
cessories with water properly and dry
them before reuse.
EN
– 11
2
17