3. Remove two hex bolts M8x16 (15) and two flat washers Ф20xФ8x1.5 (38) from the rear
stabiliser (7). Unscrew the bolts using the Allen key S6 provided.
4. Attach the rear stabiliser (7) onto the main frame (1) with the two hex bolts M8x16 (15)
and two flat washers Ф20xФ8x1.5 (38) previously removed. Tighten the bolts using the
Allen key S6 provided. Fig. 12
Step 2: Handrails, foot bars and pedals installation
1. Remove four M6x10 bolts (22) from the main frame (1) and take out two fixing plates (21)
from the box.
2. Install the axle (20) to the main frame (1) and tighten with the spanner provided.
3. Then attach two fixing plates (21) to the axle (20) with the four M6x10 bolts (22)
previously removed from the main frame. Tighten the assembly with the Allen key S5
provided.
4. Attach the handrail (5) onto the main frame (1) with two wave washers Ф26xФ16x0.3
(23), two D-shaped washers Ф28xФ16x5 (25), two flat washers Ф10xФ25x2.0 (26),
two spring washers Ф19.5xФ11.5x3.0 (27) and two hex bolts M10x20 (28). Tighten the
assembly with the Allen key S6 provided.
5. Remove one spacer (62) and right nylon nut (70) from the right pedal (61).
6. Attach the right pedal foot bar (6) onto the right crank (68) using the right pedal (61),
the spacer (62) and right nylon nut (70) previously removed. Tighten the right pedal (61)
clockwise using the spanner with Philips screwdriver provided and screw the right nylon
nut (70) counterclockwise with the spanner provided.
7. Repeat the same procedure to attach the left pedal (11) onto the left side of the crank
(62). Tighten the left pedal (11) counterclockwise using the spanner with Philips
screwdriver provided and screw the left nylon nut (82) clockwise with the spanner
provided. Fig. 13
Note
Do not turn the left pedal clockwise to tighten it or it will damage the nuts.
Step 3: Saddle post and footrest installation
1. Turn the M16x35 adjustment knob (81) from the saddle post (9) counterclockwise to
release the saddle slider (10).
2. Then adjust the saddle slider (10) slightly forwards or backwards in one of the holes to
lock it in the desired position.
3. Lock the saddle slider (10) in place by tightening the adjustment knob M16x35 (81)
clockwise.
4. To adjust the saddle height, loosen the saddle-height adjustment knob M16x25 (79) on
the post of the main frame and pull back the knob.
5. Adjust the saddle post to the desired height so that the holes are aligned, then fit the
knob and retighten it.
ENGLISH
DRUMFIT CROSSFIT 3000 EOLO
61