Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Controls
The light switch
turns the halogen lights on
and off.
The blower on/off switch turns the blower on
to its lowest running speed. The blower must
be turned on using this switch. Turn the blower
off by pressing this switch a second time.
The blower
medium speed switch changes
the blower speed to medium. This switch works
only if the blower is already running at tow or
high speed.
The blower
high speed switch changes the
blower speed to high. This switch works only if
the blower is already running at tow or medium
speed.
The pilot lamp lights up whenever the blower is on.
PILOT LAMP
O
BLOWER
HIGH SPEED
O
_
BLOWER
MEDIUM
SPEED O
o
BLOWERswITcHON/OFF O
o
LIGHT
SWITCH
HEA T SENTRY
TM
Your hood is equipped with a HEAT SENTRY
TM
thermostat.
This thermostat is a
device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature
level drops to normal, the blower will return to its original
setting.
WARNING
The HEAT SENTRY thermostat
can start the blower even if the hood is turned
OFF. When this occurs,
it is impossible to turn the blower OFF with its switch.
If you must stop the blower, do it from the main electrical
panel.
HALOGEN
BULBS
This range hood requires two halogen bulbs
(Type MR16 bulb shielded, GU10, 120V, max
50W).
ALWAYS
SWITCH OFF THE ELECTRiCiTY
SUPPLY
BEFORE
CARRYING
OUT ANY
OPERATIONS ON THE APPLIANCE.
1. Loosen
the
ring
nut
by
turning
it
counterclockwise.
2. Loosen
the
bulb
by
turning
it
counterclockwise;
pull the bulb downwards
to remove. CAUTION:
BULB
MAY BE
HOT!
3. Replace with Type MR16 shielded, GU10,
120V, max 50W halogen bulb.
I
!
BULB
RING NUT
-9-
Publicidad
