Publicidad
TROUBLESHOOTING
]
dealer to carry out repair work.
SYMPTOM
|
CAUSE
7
REMEDY
POWER
—
The power does not go
on.
= |
*
The power cord is unplugged.
The component
(amplifier, timer, etc.) to which
the cord is attached is off.
Insert the power cord correctly.
e
Turn the stereo amplifier or audio timer on.
| d
CASSETTE DOOR
The door does not open.
ES door does not close.
PLAYBACK
The tape stops
immediately.
The level meter does not
work.
There is no sound.
RECORDING
The recording (REC)
indicator does not light.
The level meter does not
work.
The tape stops
immediately.
The tape cannot be
recorded.
38
<RRE1056>
En
—
The deck is not in stop mode.
The power was turned off with the tape
moving.
Press the stop (E) button.
Turn power on.
The cassette is not properly loaded.
e
Reinsert the cassette.
The tape is completely wound.
The tape is slack.
Begin playback in opposite direction.
Rewind the tape.
|
Take up the slack (see page 6).
The tape is not recorded.
The tape heads are dirty.
The amplifier input selector is not set properly.
The amplifier volume is too low.
There are connection problems (wrong connec-
tion, poor contact, broken wire.)
The erasure prevention tabs are removed.
e
Replace the tape with a recorded one.
Clean the heads (see page 8).
Set the input selector to select the deck.
Turn up the volume.
e
Check all connections (see page 10).
e
Replace the cassette with one whose tabs are
intact, or cover the hole with a piece of tape
(see page 6).
The REC LEVEL control is set too low.
The amplifier is not delivering a signal to the
deck.
There are connection problems (wrong connec-
tion, poor contact, broken wire).
The tape is completely wound.
The tape is slack.
The tape heads are dirty.
|
e
Turn the REC LEVEL control up (see page 26).
e
Set the amplifier to select the recorded signal.
e
Check all connections (see page 10).
Begin recording in opposite direction.
e
Rewind the tape.
e
Take up the slack (see page 6).
e
Clean the heads (see page 8).
Publicidad
