Operating Machine - Nobles Speed Scrub 2601 Manual Del Operador Y Piezas

OPERATION

OPERATING MACHINE

1. Disengage the squeegee lift lever from the up
position and lower squeegee (Figure 11).
FIG. 11
2. Turn the main power switch to the on position.
3. Lower the scrub head to the floor. Press and hold
top half of brush pressure switch to lower
(Figure 12).
FIG. 12
4. Turn the vacuum and solution switches to the ON
position.
NOTE: The brushes and solution flow will start when
control grips are rotated.
5. Before starting, turn the speed control knob to
slowest setting to avoid an abrupt take--off
(Figure 13).
6. Begin scrubbing by rotating control grips forward.
Gradually increase your speed by turning speed
control knob forward (Figure 13).
10
Home Home Find... Go To.. Find... Go To..
FIG. 13
7. Once machine begins to move, check the needle
position of the brush pressure meter. Depress the
brush pressure switch to adjust pressure. Do not
operate machine in the red zone (Figure 14).
FIG. 14
ATTENTION: To prevent floor damage and brush
motor overload, do not operate brush pressure
meter in red zone.
8. To operate machine in reverse, simply pull the
reverse switch backwards (Figure 15).
FIG. 15
9. To stop machine, gradually release the control
grips.
Speed Scrub 2601 Cylindrical Brush (12- -02)