Publicidad
Idiomas disponibles
Idiomas disponibles
Always use pipe sealant tape when
connecting hoses or fittings to prevent
air leaks.
3.
Attach the other end of the 1/2" hose (E)
with 3/8" industrial quick-connect body
(purchased separately) to the "quadraport"
as shown in Figure 5.
4.
Attach 3/8" hoses (A) with 1/4" industrial
quick-connect plugs (B) to the outlets (C).
One to four tools can be used at the same
time. See figure 4.
5.
The "quadraport" can be temporarily or permanently mounted at the work site
using the three mounting holes (F). See Figure 6.
GROUNDING INSTRUCTIONS
circuit, grounding reduces the risk of shock by providing an escape
wire for the electric current. This air compressor must be properly
grounded.
If these grounding instructions are not completely
understood, or if in doubt as to whether the
compressor is properly grounded, have the
installation checked by a qualified electrician. The air
compressor is equipped with a cord having a
grounding wire with an appropriate grounding plug.
The plug must be used with an outlet that has been
installed and grounded in accordance with all local
codes and ordinances. The outlet must have the
same configuration as the plug. See Fig. 7. DO NOT
USE AN ADAPTER.
Inspect the plug and cord before each use. Do not
use if there are signs of damage.
electrical shock!
Do not modify the plug that has been provided. If it
does not fit the available outlet, the correct outlet
should be installed by a qualified electrician.
If repairing or replacing cord or plug, the grounding wire must be kept separate
from the current-carrying wires. Never connect the grounding wire to a flat blade
plug terminal. The grounding wire has insulation with an outer surface that is green
- with or without yellow stripes.
instructions are not closely followed.
This procedure is required before the air compressor is put into service. (before the
hose is installed), the check valve is replaced, or a complete compressor pump is
replaced.
The procedure:
1. Make sure the pressure switch lever is in the "OFF" position. NOTE: Your unit
could be damaged if the pressure swich lever is in the ON/AUTO position.
Note
RISK OF ELECTRICAL SHOCK! In the event of a short
Improper grounding can result in
BREAK-IN PROCEDURES
Serious damage may result if the following break-in
F
10-ENG
Fig. 6
Fig. 7
Publicidad
