Publicidad
Idiomas disponibles
Idiomas disponibles
ADEQUATE CLEARANCE, STABILITY OR SUPPORT FOR PULLING
THE UNIT UP AND DOWN STAIRS OR STEPS. THE UNIT MUST BE
LIFTED, OR PUSHED UP A RAMP.
necessary to brace or
support one end of the outfit
when attaching the wheels
and the rubber feet, because
the air compressor will have
a tendency to tip.
1. Place shoulder bolt (C) through
wheel (B) and position it into the
hole of the mounting bracket
(protruding hub to the inside).
Thread nut (A) onto shoulder
bolt and tighten firmly with a
9/16" wrench. Repeat to
install second wheel. See
Figure 2.
2. Attach the rubber feet (D) to the
bottom of the front bracket
using the screws (E) provided.
3. Rotate handle into operating
position as shown in Figure 3.
NOTE: Handles will lock into
place.
Location of the Air Compressor
Locate the air compressor in a clean, dry, and well-ventilated area. The air filter
must be kept clear of obstructions which could reduce air flow to the air
compressor. The air compressor should be located at least 12" away from the wall
or other obstructions that will interfere with the flow of air. The air compressor head
and shroud are designed to allow for proper cooling. If humidity is high, an air filter
can be installed on the air outlet adapter to remove excessive moisture. Follow the
instructions packaged with the air filter for proper installation.
Lubrication and Oil
This unit needs no lubrication or oiling.
Extension Cords
To avoid voltage drop, power loss, and overheating to the motor, use extra air hose
instead of an extension cord. Low voltage can cause damage to the motor.
If an extension cord must be used:
• use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot
receptacle that will accept the plug on the extension cord.
• make sure the extension cord is in good condition.
• the extension cord should be no longer than 50 feet.
• the minimum wire size is 12 gauge (AWG). (Wire size increases as gauge
number decreases. 10 AWG and 8 AWG may also be used. DO NOT USE 14
AWG or 16 AWG.)
INSTALLATION
THE WHEELS AND HANDLE DO NOT PROVIDE
It may be
E
8-ENG
A
B
D
Fig. 2
Fig. 3
C
Publicidad
