Flex FX1431 Manual Del Operador página 11

DIRECTION-OF-ROTATION (FORWARD/
CENTER-LOCK/REVERSE) SELECTOR
WARNING
selector in the "OFF" position (center-lock)
to help prevent accidental starts and
possible injury.
Your tool is equipped with a direction-of-rotation
selector, located above the variable-speed
trigger switch. This selector is used to change
the direction of rotation of the bit and to lock the
variable-speed trigger in the "OFF" (center-lock)
position.
a. Position the direction-of-rotation selector to
the far left of the tool to tighten bolts/nuts
(Fig. 5).
b. Position the direction-of-rotation selector to
the far right of the tool to loosen bolts/nuts
(Fig. 5).
c. Position the switch in the "OFF" (center-
lock) position to help reduce the possibility of
accidental starting when not in use.
NOTICE: To prevent gear damage, always allow
the impact wrench to come to a complete stop
before changing the direction of rotation.
ADJUSTMENTS
After tool use, lock the
direction-of-rotation
Fig. 5
NOTICE: The impact wrench will not run unless
the direction-of-rotation selector is engaged fully
to the left or to the right.
WARNING
Therefore, the direction-of-rotation (forward/
center-lock/reverse) selector should always
be locked in the center position when the
tool is not in use or when carrying it at your
side.
-11-
Battery tools are always in
operating condition.