Publicidad
Idiomas disponibles
Idiomas disponibles
MODE SELECTION (FIG. 6b)
Your tool is equipped with a mode control panel,
located on the foot of the tool. It consists of
the drive-control button, the "M" button, and
indicator lights for working modes.
The drive-control button is used to select among
three modes with preset torque, rotation-speed
(RPM), and impact-speed (IPM) for intended
application. The modes 1, 2, and 3 are the only
modes where the speed is controlled by the
variable-speed trigger switch.
"A" is a special mode, that is designed to be
used both with forward rotation for tightening the
bolts or nuts and reverse rotation for loosening
the bolts or nuts.
In the forward rotation position, the impact
wrench will stop running when the bolt or nut is
pre-tightened, and then the torque wrench can
Forward Rotation
LED indicator
displayed on panel
Maximum IPM
Working
(Impacts per
Mode
minute)
1
1000
2
2700
3
3750
A
/
/
be used to complete the work. This function has
high work efficiency and the bolt or nut will not
be over-tightened.
In the reverse rotation position, once the bolt
or nut becomes loose, the impact wrench will
stop running to prevent bolt or nut from falling
away.
The " " mode is intended for driving screws in
wood.
Using the "M" button:
Press the "M" button directly without touching
the trigger switch. The corresponding indicator
light will illuminate to indicate the active mode.
Press the "M" button briefly (less than 0.5
seconds) to cycle between "A" and " " modes.
Each press changes one mode. See more
details in the chart below:
Application
Fine-tuned tightening of small bolts and
nuts.
Moderate tightening torque.
Maximum tightening torque.
Tightening with automatic stop.
Greatly increase the screwing speed
when driving screws in wood.
-13-
Publicidad
