Flex FX1431 Manual Del Operador página 12

LED WORK LIGHT (FIG. 6a & 6b)
Your tool is equipped with the LED work light
with adjustable brightness. This provides
additional light on the surface of the workpiece
for operation in lower-light areas.
To adjust work light brightness:
1. Press the "drive-control button" and "M"
button simultaneously for 2 seconds until the
five indicator lights start flashing for 0.5s on
and 0.5s off at the same time, indicating that
the tool has entered the work light brightness
adjustment mode.
2. In the work light brightness adjustment mode,
each time you press the trigger switch, the
brightness will change to the next level and
will cycle among the following six brightness
levels.
1 2
Light off
Lowest
3. Press the drive-control button or "M" Button
to exit the work light brightness adjustment
mode. If there is no operation for 5 seconds,
the tool will automatically exit the brightness
adjustment mode.
NOTE: While in the work light brightness
adjustment mode, the trigger switch will only
function as a brightness adjustment "button".
The next time the tool is turned on, the memory
function will remember and revert to the last
work light brightness level.
The light will turn off automatically approximately
10 seconds after the trigger switch is released.
3 4 5
Highest
Fig. 6a
LED Work Light
Fig. 6b
6
Drive-control Button
-12-
"M" Button
Indicator Lights