Be Fore Using Your App Lian Ce F Or The F Ir St T Im E - Oster BVSTEM6702B Manual De Instrucciones

APP LIAN CE F OR THE F IR ST T IM E
CLEANING AND PRIMING THE UNIT PRIOR TO FIRST USE
Please refer to the "Description of the Appliance" section to familiarize yourself with
the product and identify all parts.
1. Please make sure the unit is off "O" by pressing the on/off "I/O" switch located on
the right side of the unit. Make sure it is unplugged from the electrical outlet.
2. Remove stickers and labels from the unit.
3. REMOVE RED PLUG FROM THE BOTTOM OF THE WATER RESERVOIR.
4. First remove and then wash the water reservoir, the milk reservoir, the two
porta-filters, the three filters and measuring scoop/tamper in a mixture of mild
detergent and water. Rinse each thoroughly and place them back into the unit.
5. Refer to the instructions on "PLACING THE PORTA-FILTER" section before placing
or removing the porta-filter and any filter from the unit.
6. To clean the inside of the appliance, follow the steps listed on the "PREPARING
CAPPUCCINO" section using water in both reservoirs and no ground coffee in the filter.
Do not immerse the appliance in water or attempt to reach any of its internal parts.
IMPORTANT - PRIME THE UNIT
To prime unit, run the steam cycle by following the steps below:
1. Fill water reservoir up to the "MAX" line and make sure to place the water reservoir
tightly back in the unit with its lid closed (if you removed it to fill it up).
2. Fill the milk reservoir with water up to the MAX level and place the milk reservoir
back in its place. You should feel the milk reservoir lock in place.
3. Select one of the filters (single or double espresso) and place it in the porta-filter
for ground coffee. Place the porta-filter in the unit ensuring it is properly locked and
place a large cup under it. Also, make sure the tip of the frothed milk dispensing
tube is pointing inside the cup.
4. Plug the appliance into the appropriate outlet.
5. Turn the power button on "I".
6. The 2 control panel lights (Espresso heater " " and Steam heater " ") will start
blinking. Once these lights become solid, press the manual espresso button
" ". The water will flow and stop automatically.
7. Press the manual froth button "
Milk Froth Level Control Knob should be set in the Latte " " position.
8. The 2 control panel lights (Espresso heater " " and Steam heater " ") will turn on
solid. Now your unit has been primed and is ready to be used.
BE FORE USING YOUR
". The water will flow and stop automatically. The
E n g li s h - 5