Turning The Unit On - Oster BVSTEM6702B Manual De Instrucciones

PLACING THE PORTA-FILTER
a. Position porta-filter underneath the brew head. Refer to figure "A" below.
b. Position handle so that the handle lines up with the open lock icon "
and fits into the groove. Refer to figure "B" below.
c. Then, slowly turn it to the right until the handle is aligned with the closed lock symbol
" " on the unit. Refer to figure "C" below.
a.
PLACING THE CUP(S)
a. Adjust the height by inserting the removable drip grid in the height-adjusting slot
if you are using a small "demitasse" cup(s) to brew espresso or OriginalLine
Nespresso *. Refer to figure "A" below.
®
b. Keep the removable drip grid on top of the removable drip tray if you are using a
larger cup to brew cappuccino or latte. Refer to figure "B" and figure "C" below.
CAUTION: When brewing cappuccino or latte, please make sure to adjust the frothing
tube lever in order to position the frothed milk dispensing tube to point inside the cup that
is being used.
a.

TURNING THE UNIT ON

a. Make sure unit is plugged into the appropriate electrical outlet.
b. Turn unit on "I" using the on/off "I/O" switch located on the right side on the unit.
The 2 control panel lights (Espresso heater " " and Steam heater " " ) will start blinking
during the heating process and until the water and milk (if preparing cappuccino or latte)
reach the perfect temperature. Once these lights become solid, the unit is ready to use.
b.
b.
a.
E n g li s h - 9
" on the unit
c.
c.
b.